Sets up Multi-Signal Radar Stations for Long Range Circuit Network Signal Sharing.
SETUP:
When setting up, the Parameterised blueprint will hold both the sender and the reciever. This is done to ensure they're synced correctly. Simply cut the receiver side (the right) and paste it in the new location. When setting up, ensure that the full receiver is built before giving it power, otherwise it may not function correctly.
Sender: Input is will be any green cable connected to the constant combinator. You can use the constant combinator to test the signal if you don't currently have an active output, just remember to turn it off when correctly setup. When setting up the sender, be sure to set the quality band through the selector combinator to the same that you will be using for the receiver.
Receiver: Output is the Green cable attached to the right Medium power pole. When setting up, ensure to select the correct quality band through the second from the top selector combinator. It should be set up to the same quality as the sender. DO NOT MODIFY THE TOP SELECTOR.
Additional Notes: This Blueprint allows the sending of all normal signals other than the signals seen in the Radar Checker and the Sube Symbol and the tile ghost Symbol. You cannot feed quality signals into this system correctly.